PT100/25kg
adobe finish for exterior base or mesh coated surfaces, min 1mm.
PT100 comes in 25kg bags
PRODUCT INFO
adobe finish for exterior base or mesh coated surfaces, min 1mm.
TECHNICAL INFORMATION
Adobe Finishing Render HEIDELBERGER PT100PT 100 Adobe Finishing Render is a factory mixed dry plaster following European standard DIN 18550 and DIN 18555 and is suitable for use as a topcoat.PT 100 Adobe Finishing Render can be applied to exterior surfaces as a topcoat and can be used on all masonry substrates (walls and ceilings).PT 100 is a finishing render and is normally used as the final coat on top of a basecoat. For basecoat details, see PT 200, PT 300, PT 320, PT 325 or PT 350 Technical Information sheets. PT 100 has been specifically formulated as a fine sponge finish and is ideally suited where an adobe or undulating finish is required.PreparationThe substrate must be of a sound nature, free from dust and loose particles, form release oils and other contaminants which could affect adhesion and bonding strengths of subsequent coatings.ApplicationWith excellent adhesion and having a favourable compression/flexural strength ratio, PT 100 is suitable for commercial plastering machines. PT 100 can, however, also be applied manually when mixed by drill or machine (e.g. M-Tec D20).PT 100 can be applied from 1mm to 5mm thickness.During setting the applied areas may be screeded, floated, sponged or brushed with water to achieve the required finish. PT 100 can be easily worked to any desired effect, from bold rustic and undulating textures to smooth sponge finishes. For a smooth sponge finish it may, depending on the straightness of the basecoat, be necessary to apply two coats of PT 100.CoverageDepending on the substrate a 25kg bag of PT 100 yields approximately 7 square metres at 2mm thickness.Page | 14ImportantDo not under any circumstances add foreign substances other than clean water to premixed mineral plasters.PT 100 should not be applied to wet or green cementitious substrates before a reasonable curing/drying period.Paint should not be applied to mineral plasters until sufficiently hardened and dried. If in doubt contact Putz-technik.TechnicalPT 100 is manufactured using selected grades of sand, lime, cement and mineral additives. Sand particle size range is 0—1.0mm.PT 100 has high water vapour permeability (breathing activity). Where a re resistance rating is required please contact Putz-technik. Water demand 600(wf) (0.30)Air-Entrainment vol %16.6Water retention % 95.4Flexural strength N/mm²1.00Compressive strength N/mm²2.3Bond strength N/mm²0.45StoragePT 100 is packaged in 25kg paper bags, with 40 bags (1 tonne) per pallet. PT 100 can be stored in a dry place for up to 6 months.Quality ControlPT 100 is quality controlled at point of manufacture and tested by independent laboratories.ServiceAt the forefront of plastering technology, Putz-technik offers its assistance and experience in the selection and use of our products and machines.Demonstrations are available on request.I’m a Return and Refund policy. I’m a great place to let your customers know what to do in case they are dissatisfied with their purchase. Having a straightforward refund or exchange policy is a great way to build trust and reassure your customers that they can buy with confidence.
SHIPPING INFO
I'm a shipping policy. I'm a great place to add more information about your shipping methods, packaging and cost. Providing straightforward information about your shipping policy is a great way to build trust and reassure your customers that they can buy from you with confidence.